Fabrics & Sheers

How Your Curtain Heading Changes the Way It's Cleaned

The heading at the top of a curtain changes how it should be cleaned because it decides how easily the curtain comes down, what hardware is attached, and whether stiffened pleats can survive water. Eyelet and rod-pocket curtains slide off and are often simple to wash or send out; pinch-pleat, wave and pencil-pleat curtains on hooks or gliders are fiddlier to remove and rehang, and their stiffening tape can soften or pucker if washed, so they're often better suited to onsite cleaning on the track. Looking at curtain heading types before cleaning saves damage and a lot of re-hooking.

Here's how the common headings found in Melbourne homes compare, and what each one means for cleaning, including when onsite curtain cleaning in Melbourne makes more sense than taking curtains down.

What the heading actually does

The heading is the top band of the curtain that attaches it to the track or rod. Inside most tailored headings is a strip of stiffening, often called buckram or heading tape, that holds the pleats or folds in shape. On top of that sit the hooks, gliders, rings or eyelets that carry the weight.

All three parts matter for cleaning:

  • The stiffening can soften, shrink or go wavy when soaked, so the pleats don't stand up the way they did.
  • The hardware has to come out before machine washing, and metal parts can leave rust marks on wet fabric.
  • The way it hangs decides how long removal and rehanging takes, which is also part of what you pay for.

Common curtain heading types and how each is cleaned

Pinch pleat

Groups of two or three folds stitched together at the top, with a hook behind each group. It's a classic look in older Melbourne homes and many apartments. The buckram is sewn in permanently, and soaking it in a domestic machine often leaves the pleats limp or crooked. Taking down a wide pinch-pleat curtain also means unhooking dozens of hooks from a ceiling track. These are a strong candidate for cleaning where they hang, or for professional dry cleaning if the fabric needs it.

Pencil pleat

Narrow, tight gathers made by pulling cords in the heading tape. The tape can be loosened for washing, then pulled up again, but getting the gathers even across the width takes patience. Water can shrink the tape and the fabric at different rates, so the heading may pucker afterwards.

Eyelet (grommet)

Metal or plastic rings punched through the top, threaded straight onto a rod. These are the easiest curtains to remove. The catch is the rings: cheaper metal eyelets can rust or tarnish in water and leave rings of staining on the fabric around them, and a hot dryer can warp plastic ones. If the fabric is washable, a cold gentle wash with a mesh bag is often fine.

Rod pocket and tab top

A sewn channel or fabric loops that slip over a rod. No hardware is attached to the fabric, so they're simple to take down and put back. They're often lighter, unlined curtains, which makes washing practical if the label allows.

Wave or S-fold

A soft, continuous ripple created by snapping the heading onto carriers spaced along a special track. It's common in newer builds and commercial fit-outs. The snap tape and carrier spacing have to line up exactly when the curtain goes back up, otherwise the folds look uneven. Onsite cleaning avoids that problem completely.

Box and inverted pleats

Flat, tailored folds, often on formal drapes and roman-style pelmets. They rely on crisp stiffening and careful pressing. Water tends to undo them, so dry cleaning or careful onsite cleaning is usually the safer choice.

Quick comparison

HeadingEase of removalWater risk to headingOften suits
Pinch pleatSlow, many hooksHigh: pleats can go limpOnsite cleaning or dry cleaning
Pencil pleatModerateMedium: tape can puckerOnsite, dry clean, or careful wash
EyeletEasyLow to medium: ring rustWash if fabric allows, or offsite clean
Rod pocket / tab topEasyLowWash if fabric allows
Wave / S-foldModerate, must realignMediumOnsite cleaning
Box / inverted pleatModerateHighDry cleaning or onsite

The heading isn't the only factor. Fabric, lining and condition still decide what's safe, so treat this as one piece of the picture.

Can you wash curtains with pinch pleats at home?

You can, but it's a gamble. If the face fabric is washable polyester and the buckram is a modern synthetic, a cold, gentle wash may come out fine. More often, the stiffening absorbs water, the fabric around it shrinks slightly, and the pleats end up leaning or floppy. Ironing them back into shape is slow, and you're working on a ladder to rehang a heavy, damp curtain.

If you decide to try it:

  1. Photograph the curtain on the track first, so you know which hook goes where.
  2. Remove every hook and count them.
  3. Wash cold on the most delicate cycle, one curtain at a time.
  4. Don't wring or tumble-dry. Rehang while slightly damp and finger-press each pleat into place.
  5. Use a sturdy ladder on level ground, and get someone to hold it and take the weight of the curtain.

Most people who've done this once prefer not to do it again, especially for wide living-room windows or double-height voids.

Why onsite cleaning suits tailored headings

With onsite curtain cleaning, the curtain stays on its track while the fabric is cleaned with steam and hot-water extraction. The heading stays hooked in place, the pleats keep their spacing, and there's no ladder work for you. It's well suited to pinch-pleat, wave and box-pleat curtains in sturdy fabrics. Our explainer on what onsite curtain cleaning involves walks through the process.

It isn't right for everything. Silk, delicate linings and fabrics that shrink with moisture are better taken down for offsite dry cleaning, then returned and rehung. If you're torn between the two, the guide to onsite vs offsite curtain cleaning sets out the differences. And because heading type affects how long removal and rehanging take, it's one of the things that shows up in a curtain cleaning quote.

A few honest limits: very old buckram that has already gone brittle may not stiffen up again whatever method is used, and pleats that were badly set when the curtain was made won't be fixed by cleaning.

Book a clean that suits your curtain headings

Tell us what headings and fabrics you have and we'll suggest onsite cleaning on the track or offsite dry cleaning with rehanging. We work across Melbourne, and you can check our service areas or call (03) 9125 4547 for a free quote.

FAQ

Questions people ask us

Short, straight answers. Anything else, just call.

(03) 9125 4547

Do I need to remove curtain hooks before dry cleaning?

Yes, metal and plastic hooks should come out before any curtain goes to a dry cleaner, because they can snag, mark or damage the fabric and machinery. If your cleaner takes the curtains down for you, they'll normally handle the hooks and put them back when rehanging. Keep any spare hooks in a labelled bag.

Will cleaning make my pencil pleat curtains shorter?

It can if the fabric or heading tape shrinks in water, which is why cold washing and drip-drying matter. Dry cleaning and onsite cleaning use far less water on the heading, so shrinkage is less likely. Measure the drop before cleaning; if a curtain was already barely touching the sill, mention it when you get a quote.

Is the curtain track cleaned too?

Tracks and rods collect dust and can make curtains run roughly, so it's worth wiping them when curtains are down or being cleaned. A dry microfibre cloth works for most tracks. Avoid spraying lubricants near the fabric. If a track is bent, sagging or missing gliders, a curtain installer is the right person to fix it.

Let’s freshen up your windows

Tell us what’s hanging and we’ll quote it: curtains, sheers, drapes and blinds, cleaned where they hang or taken away and rehung, anywhere in Melbourne.

Call