Blinds
Keeping Blinds Clean Between Professional Cleans

The simplest answer to how to keep blinds clean is little and often: a quick dry dusting every week or two, a slightly more careful going-over once a month, and fast attention to spills, grease and moisture before they set. Blinds that are dusted regularly rarely build up the grey film that needs heavy cleaning, and they look better for longer between professional visits.
Below is a practical routine by blind type, the tools worth having, and the habits that quietly undo your effort. When a blind is past what a duster can fix, our Melbourne blind cleaning service can take over.
The kit you actually need
You don’t need specialist gear. A small, cheap set covers almost every blind in the house:
- Microfibre cloths, a few of them, so you can swap to a clean one as each loads up with dust
- A vacuum with a soft brush attachment and, ideally, adjustable suction
- A slatted-blind duster or a clean cotton glove for running along venetian slats
- A lint roller for fabric romans and rollers that attract pet hair
- A bowl of lukewarm water with a drop of mild dishwashing liquid, for hard blinds only
- A stable step stool or ladder, because leaning off a chair to reach a top rail is how people get hurt
How often should you dust blinds?
There’s no fixed rule, but this rhythm suits most Melbourne homes. Rooms facing a busy road, homes with pets, and anywhere near a kitchen need the shorter end of each range.
| Task | How often | Notes |
|---|---|---|
| Dry dust or light vacuum | Every 1–2 weeks | Takes a few minutes per window once it’s a habit |
| Both sides, top rail and bottom bar | Monthly | The window side collects more dust than you’d expect |
| Damp wipe of hard slats | Every few months | Aluminium and PVC only; never soak |
| Check for mould and marks | Monthly in winter | Look at the glass side and lower edges |
| Professional clean | When a routine clean no longer lifts the dullness | Kitchens and damp rooms usually need it sooner |
How to keep blinds clean, type by type
Venetians (aluminium, PVC and timber)
Close the slats so they face one way and dust from top to bottom, then tilt them the other way and repeat. Working downwards means any dust you knock loose lands on slats you haven’t done yet, not ones you’ve finished. For aluminium and PVC, a cloth barely dampened with soapy water and then a dry cloth behind it will shift light grime. Real timber should stay dry: moisture can warp slats and lift the finish, so stick to a dry microfibre or a soft brush.
Verticals
Close the blades and run the soft brush down each one in the direction of the weave, holding the bottom of the blade lightly so it doesn’t swing. Check the bottom weights and chains, which collect fluff and grime, and give the headrail a pass with the brush attachment.
Rollers and blockouts
Lower the blind fully so you can reach the whole surface. Vacuum gently from top to bottom with the brush on a low setting. Don’t scrub the coated side of a blockout; rubbing can scuff or crack ageing coatings. Spot marks are best dabbed with a barely damp cloth, after testing a corner.
Romans
Dust settles into the folds, so lower the blind flat before vacuuming. Use low suction to avoid dragging the fabric against the cords and rods inside. Many romans are lined and contain battens, which makes washing them at home risky.
Room-by-room trouble spots
Some rooms work against you, and knowing why helps you stay ahead.
- Kitchens: airborne cooking grease settles on blinds and turns dust into a sticky layer. Using the rangehood every time you cook makes a real difference, as does a more frequent wipe of hard slats.
- Bathrooms and laundries: steam encourages mould. Run the exhaust fan, leave the blind partly open after showers so air can move, and avoid fabric blinds in rooms with no ventilation if you can.
- Bedrooms: winter condensation on the glass can wet the back of a blind overnight. Wiping the window in the morning and opening the blind for an hour helps it dry out.
- Street-facing rooms: traffic grime and pollen blow in through open windows. During spring, when grass pollen peaks roughly from October to December, keeping an eye on the Melbourne Pollen Count can tell you when to keep windows shut. Our guide to curtains, blinds and pollen season has more on this.
Habits that make blinds dirtier
A few common shortcuts cause more harm than good:
- Spraying cleaner straight onto the blind. Liquid runs into headrails and mechanisms and can leave tide marks on fabric. Spray the cloth instead.
- Using bleach on mould. It strips colour, weakens fibres and coatings, and is dangerous if mixed with ammonia or vinegar based products.
- Soaking fabric blinds in the bath. Stiffeners, coatings and glued seams often don’t survive it, and a rolled-up wet blind can grow mould.
- Abrasive pads. They scratch slats and wear fabric.
- Leaving fabric blinds closed against wet glass. That’s the easiest route to black spotting.
If you do spot mould, put on gloves and a P2 mask, ventilate the room and avoid dry-brushing it indoors, which spreads spores. Light surface spots on a hard blind can be wiped; spotting that has soaked into fabric usually needs professional treatment, and may lighten rather than vanish completely.
When routine care isn’t enough
Regular dusting slows the build-up, but it doesn’t remove the fine, embedded soil that dulls fabric over time. It’s probably time for a deeper clean when a blind still looks grey straight after dusting, when slats feel tacky, when there’s a musty smell, or when mould has appeared. You can read about the different approaches in how each blind type is cleaned.
Professional blind cleaning across Melbourne
Melbourne Blinds & Curtains Cleaners cleans venetian, vertical, roller, roman and holland blinds in homes, rentals and businesses, either onsite or taken away when that’s safer; our guide to choosing onsite or offsite blind cleaning explains the difference. To find out whether we cover your area, see curtain and blind cleaners near you, or call (03) 9125 4547 for a free quote.


